www.steam-engines-for-sale.com

Part Built for sale

Change Category :

We have 71 listings for : Part Built for sale
Your are on PAGE 1
  1    2    3    4    5    6    7    8    9    >  

 

Important message from site admin - Please Read >

 



7.25 jessie - ken swan design - part built.


for sale
7.25 jessie - ken swan design - pa...
71/4 jessie, nearing completion.


7.25 gauge brakevan.


for sale
7.25 gauge brakevan.
This brakevan is based on one curr...


Part built 3 inch atkinson steam wagon.


for sale
Part built 3 inch atkinson steam w...
Completed chassis,front and rear a...


Southern maid.


for sale
Southern maid.
Two and a half inch gauge lbsc.s s...


5inch gauge gwr 0-6-0t pansy locomotive.


Sold
5inch gauge gwr 0-6-0t pansy locom...
90% complete with full running cha...


3.5inch rob roy .


Sold
3.5inch rob roy .
Rolling chassis with nearly finish...


3.5 inch gauge juliet saddle tank.


Sold
3.5 inch gauge juliet saddle tank....
Up for sale is my 3.5 inch gauge 0...


Lbsc 3.5 inch gauge maisie.


for sale
Lbsc 3.5 inch gauge maisie.
near-complete loco being sold as ...
We have 71 listings for : Part Built for sale
Your are on PAGE 1
  1    2    3    4    5    6    7    8    9    >  

For Sale
Small turbine with ram pump.
Small turbine with ram pump.
Im not too sure exctly what this is but it looks to be a small turbine or water pump. It is not a boiler feed pump. . ....

For Sale
Edgar t westbury wyvern gas engine.
Edgar t westbury wyvern gas engine.
Nice example of the wyvern gas engine.. ....

For Sale
5inch electric diesel .
5inch  electric  diesel .
5inch electric diesel . ....

For Sale
Stuart turner lighting set and base.
Stuart turner lighting set and base.
Never seen one of these before. It is a boxed stuart lighting plant with boxed Stuart mahogany base. ....

For Sale
Early version stuart s 50 horizontal mill engine.
Early version stuart s 50 horizontal mill engine.
Nice early version s 50 when they used gunmetal castings for the cylinder and cap. ....

Welcome Guest
Member log in >
Not a member? Join here >